Pac Us445cn 1 Manual. MITSU PACUS445CN1,PACUS444CN1,Mitsubishi Electric,MITSUBISHI PAC-US444CN-1: DIMENSIONS AND WIRING DIAGRAMS Form # SB_PAC-US444CN-1_201801 Specifications are subject to change without notice The PAC-US445CN-1 Thermostat Interface must be installed in the PAA unit control Thermostat Interface
MITSUBISHI PACUS445CN1 Thermostat Adapter Interface Instruction Manual from device.report
installation manual: PAC-US444CN-1 Thermostat Interface (1) 2 Note: When either Y2 or W2 is left unconnected, it is recommended to set SW2-6.
Purchase Your HVAC Equipment Direct | Goodman AC And Furnace. Check that the box includes the following parts in addition to this installation manual: • 1 x Thermostat Interface 2 (PAC-US445CN-1) • 1 x PAA unit accessory cable 2.Safety precautions • Thoroughly read the following safety precautions before use Mitsubishi Thermostat Interface PAC-US445CN-1 - Got Ductless
Mitsubishi Electric Corporation PACUS445CN1 Thermostat Interface. Note: When either Y2 or W2 is left unconnected, it is recommended to set SW2-6. • Hazards that can occur from incorrect handling are classified by the symbols below:
Mitsubishi Electric Corporation PACUS445CN1 Thermostat Interface. Page 6 SW2-6: Adjusts indoor unit operation during stage 1 heating and stage 1 cooling according to the following table: SW2-6 Operation during stage 1 Full capacity The capacity is adjusted so that the room temperature is adjusted (heated or cooled) at a fixed rate Thermostat Interface DIP switch settings for PAA unit only SW2-4: Adjusts PAA unit Mode 23 function settings according to the following table.